How To Flash A VU+ SOLO Linux Enigma2 Receiver
world-of-satellite.co.uk
How to Flash a Vu+ Solo receiver by USB:
Fully power the receiver down by removing the power cord or turning it off at the mains.
Make sure no USB devices are plugged into the receiver at this point.
Insert the USB stick containing the image files into the USB port on the receiver.
Power the receiver on.
The orange / red light on the front of the receiver should be solid while the image is being flashed, DO NOT power off or remove the USB stick.
After a few minutes the orange / red light on the receiver should start to flash green, at this point you can remove the USB stick and press the reset button on the rear of the receiver to reboot.