How To Flash A VU+ SOLO SE Linux Enigma2 Receiver
world-of-satellite.co.uk
Flashing the Receiver:
– Fully power the receiver down by the toggle switch at the rear of the receiver.
– Make sure no USB devices are plugged into the receiver at this point.
– Insert the USB stick containing the image files into the USB port on the receiver.
– Power the receiver on.
– The Blue L.E.D will quickly flash two or three times then start to fade in and out slowly.
– Once completed the Blue L.E.D will flash rapidly.
– If in doubt leave the receiver for a full 10 minutes before powering down and removing the USB stick.
The flashing process should take approximately two to four minutes to complete, while the receiver is being flashed it is vitally important that you DO NOT power the receiver down for any reason as this can cause serious and or permanent damage.
If the receiver bypasses the flash files on the USB stick and boots into the existing image you may need to check that the file structure is correct on the USB stick or try formatting the USB stick
( also try a different one ).