How to flash an enigma2 image on Golden Media CR 990 HD LX

Introduction

1. Prepare a USB stick with 1 partition in FAT32

2. Set the default system boot for [enigma2]

3. Create a directory on the pendrive enigma2

4. Copy the uImage and e2jffs2.img a previously created directory enigma2

Upload Image Enigma2:

1. Turn off receiver

2. Connect the USB stick ready to receiver

2. On Front panel hold [OK] and then turn the power switch

3. After about 5 seconds, the display should appear in the display [FORCE] then you should release the [OK] and press [V +]

4. If everything was done correctly the display flashes [U LD] which means that the image is loaded

5. After finishing the upload operation should be released shows [Succ], and the receiver will reboot automatically