OpenPli 11.2 DM500HD original

Aaah!

I have somewhere in my old time a spray for that - IF one time will work :)

So, I must "Back to Old scool" :)

Ok, Here is the result:

I have try it in all Third Example's that i found on Forums: --> "By Captain" ATV V6.3 & V7.3 - PurE2, Normal booting with Openpli V11.2 & V12.3 & Manual expanding with "nfidump".

--> Openpli Multiboot works fine -but, only installing, no one image have been started (Tested 5 images - 'openvision' 'nonsolo'...)

--> OpenAtv V6.1 -- missing 'nfidump' command line in OpenATV was very strange -without this one I can't go on.

(Formating SSD)

--> For some reason in OpenAtv 'Flashexpander' don'T work -crashed all the time, 'Gparted' doesn't mount.

Anywhere, I managed Partition in 'Linux' but, in the end still works only the script from "Captain" Jack :)))

Was not installed any advanced or another image on SSD.

Nice Job 'Captain'!!!

Somewhere in the middle of one night, all this commands that mess in my 'Head' I realize that:

--> for some "reason" ( I guess that'S is from "Captain" Reason ) --> the actual work is On SSD, but, I have no possibility to flash other images because 'Mutltiboot' isn'T Full installed - missing some kernel (kernel.module.block2mtd).

- trying to install him just give an ERROR.

--> LAst one Try - PurE2 V6.2 - Image works so smoothly, that i have lost nerves after trying to start a script 'flodder.sh' -run once:)

Just say 'there is no flodder.sh' and 'Folder already exists'... :))

I know this tread's is obsolete all, but writing a tread's that is not helping people isn't a place to be :)

Result:

--> No one from these images can handle the "rtsp" commands for Playing just a video stream - 'http' is ok.

- OpenAtv works better from PureE2 - && comparing with last now OpenPli Version here V12.3 too :)))

- OpenPli load just fine - boot of them, V11.2 and V12.3 :)))

Conclusion of all mess:

--In 'Flash' installed PurE2 V6.2 - in 'SSD' -OpenAtv V6.1.

...testing...

- I have Try it with cutted POWER directly from cord - without putting Receiver in 'Standby' Mode -Booting like a sharm.

When Power is cutted OFF from cord - I bring out exSATA cable -than run smootly PurE2, when put it back - run OpenAtv

- Without Multiboot

DM 500HD -Multiboot SSD.png

... and doesn't matter what in BIOS is :))) ...ops of course Does, but ... just BIOS don'T give me a chance to change it.

(after Reboot, take Factory defaults). 'Scripted'? O Yea, but good

Screenshot (313).pngScreenshot (312).pngScreenshot (314).png

So, I have 2 images that Run's on my DM 500HD now.

Don'T ask "how I did it?" because I don't know, exactly

(... or maybe because somewhere in the middle i just install the last version of 'flodder'?? Booo )

Any idea for "rtsp" commands will be just fine before i "give'up".

Best regards and thanks all for Good Works (including myself)