New Version 2.3
Correct some problems whith Disable-Enable-Restart-Delete-Server
Correct some problems whith CccamConverter
Add Wicardd UpdatServer
Key_9 Wicardd
No Discussion here
New Version 2.3
Correct some problems whith Disable-Enable-Restart-Delete-Server
Correct some problems whith CccamConverter
Add Wicardd UpdatServer
Key_9 Wicardd
No Discussion here
now no one answers ....... :thumbdown::thumbdown::thumbdown:
Is there anyone among you who can provide me a good
wicardd.conf
thank you in advance
@ hotmtk
No ...;(
zgemma h2 with openatv
when you push red button not write cccam.cfg but change from left column to left
make sure of the address of your cccam.cfg
I'm asking someone to create a .deb
@ dotai
key_8 Setup plugin disables View Info Emu
once install the plugin key_8 required to configure the file addresses
may be in the next version
for the simple reason that I used all the numbers and key possible so there is nothing left for the wicardd ...;(:D
for your second request unfortunately no
wiccard damage he is no longer supported
I did not understand your question but if you talk about UpdatServer on_off
you choose the time of your choice and you choose Emu of your choice then the time
btw i use Cccam...
if you use cccam you have to put the address of your cccam.cfg file in panelsetup KEY_8
thanks for answer aime_jeux! i did write like this on that settings : /etc/CCcam.cfg ..... and when i restart stil having some problems. Ip: No Activated Port: No activated... i confiip : 192.168.1.9 confi port: 24 autoupdate: Yes port/Cccam : 8181 UpdateServer on_off : Yes.... where do i do wrong?
if you have set your ip and port correctly
to remove No activated go in panel setup Key_8 and change View Info Emu for yes
if the address /etc/Cccam.cfg so you put / etc / nothing else
btw i use Cccam...
if you use cccam you have to put the address of your cccam.cfg file in panelsetup KEY_8
forgive me
sometimes I do not understand your remarks so I can not answer !!!!!!!!
I have to put the IP address of my receiver seen and for port I must not put 8181 but oscam gcm and ncam is his thank you
in your oscam.config file or ncam.config or gcam.config you will find
[webif]
httpport = 8181
httpuser = root
Hello I put the version 2.2 and m indicates below IP and port problem I have to put what in ip and port thank you
ip = demo (box)
port = oscam,ncam,gcam
It works in vuplus ultimo 4k and open esi image 5.5
But when u press blue or red buttons it goes to list of choices
just a question if you have configured the addresses of your oscam.server and cccam.cfg files in panelSetup Key_8