my dish did move in high winds i set it back using the *** box to set the signal but when i put the cable back in my 1 meter dish i had these high figures in some of the chanels on agc and ber an example would be on 13east i get jsc sports 1 to 10 no problem but cant get *** calcio 1 to 15 or n***sports 1 to 7 and on 16 east i get high signals on agc and ber on all the tring channels all of these channels i was getting before i adjusted the dish
Posts by manuman
-
-
Hi i get some channels on different sats and dont get other channels on the same sats. I get high agc and high ber signals what is the problem can any body help please.
-
Ok thanks for quick reply Glenviewjf
-
Hi i am getting my broadband provider changed tomorrow just wanted to know will it affect my card sharing eg. my connection to my hub do i need to do anything to keep my dreambox going
-
Yes back on ??????????????????????????????????????????????????
-
Server down again is there anything i can do.
-
Ok thx scoot i will try to get started
-
ok thx
Can u tell me how to get some shares and how do i send the lines to my peers ( is it by email)
thats probably a stupid question please forgive me. -
Hi i am trying to get my dreambox 600pvr set up for free cardsharing
I have seen on various posts that i need the CCcamInfoPHP software
Could any one tell me what this is and why i need it please. -
Thx Ten just figured it out with the hrlp from your picture.
-
Thanks for the picture Ten Below i have that but how do you get var/etc where its at on yours
I just have 2 lines below where it says name which are ras a load of number here
rom-0 as aboveThats all thats in that box
-
I spent from early morning until late last night trying to do this but i dont think i have made much head way LOL
-
I cant find the file var/ect in the dcc
-
When i put a f or c line in can i do it in the dreambox using my remote?
-
cant find ccam.config in the dcc software
-
Ok now i am just lost need help please
-
ok have that done and has accepted the password what do i do next?
-
When you say connect i am connected to the dreambox via dcc there is a green line between the box and my laptop
-
I am from the north too but the guy is from Donegal
-
when i put in psswd in the telnet and enter it comes up valid commands are and shows sys ip show exit bridge set ether dot1q 1an wan pktqos and i cant get any further and he is a pay server although he is in hospital badly injured fractured skull, and a load of broken bones so i think we should forget about him his family are very concerned about him