I've searched the forum and not found an answer to my question on how to set software limits for a positioner in 1.7.9. In the menu I see the options for software limits, but I'm not clear on how exactly to set them. The positioner hardware limits (20W) cannot go down as far as I need (12W), so I'd like to set in software. Apologies if I've missed any posts on this subject, or content in the guides. I'm probably missing something obvious in the menu, and don't mind anyone pointing that out to me if I have. Thanks!
Posts by toodlepip!
-
-
Hi, new to the forum and would appreciate comments and/or feedback.
I'm planning to install a motorised dish on the south-south-east elevation of a house with line of sight from 8W to 42E, with trees obstructing E until 57E. The dish will go above the kitchen extension (roof) and below the building roofline. I could fit a 1m dish here, but will it bring in more than an 88cm or 90cm to make it worthwhile? The location is along the A45.
The bottom of the garden is about 25m away with a clear view over the rooftop west. Can I put another dish here, and feed both dish signals into a VU+ Solo2 tuner? Just in terms of budget, I could go up to a 1.2m dish here if needed.
Is there a way to distribute signals over a household LAN (or wireless) to, say a PC, or tablet?
