Posts by stevenlee1981

hi all, thanks everyone for there help and after all most a week ive got it working:36_002:

i put the DHCP on on the box, nameserver and gateway changed saved it reset box and superhub, turned DHCP off then put in the fixed ip back in and left the nameserver and gateway to what it changed to and all is good,

i did this befor but went off im 1 min but been on for 3 hours now and all is good lol

sending out c lines ok and reading c line ok off my mate now

did a network test on my dream box and still says network setup not ok but all is working :confuse:

Quote from Inspiral

Vm super hub -> 192.168.0.1

Receiver settings
If using manual/static I.P set as 192.168.0.2

Ensure nameserver is same as Router -> 192.168.0.1

I looked on teamviewer for him we got his port confirmed open

I left him saying it's his DNS settings in router that's the issue.

As said a few times in this thread? he'd be best with superhub in modem mode?
& adding his old router again ?

Inspiral

Display More

my old router not working right mate ive got to reboot it all the time thats why virgin came out

hi all sorry not been replying been to work, when i had a modem and the d link dir-615 it was working fine, my dream box had a fixed ip 192.168.0.102, when i got the super hub i didnt changed no settings all i did is but the ip 192.168.0.102 and port into the super hub settings and thought all should be ok sill, well master G did it for me

its sending out c lines ok its just not reading a c line, at 1 time i thought the c line might of been offline so i got 2 24 hour test off some one and there didnt work

ive changed the Ethernet cable rebooted the box a hub loads of times, i did turn the DHCP on then rebooted the box and it did start reading a c line for about a minute then went back off, so i put the ip 192.168.0.102 back on the box

Quote from abu baniaz

You are having networking issues. Start at the lowest level and work upwards.

My advice is:
Set all devices to dhcp.
Make a note of the mac addresses of devices you want to have specific IP addresses. I have deliberately not used the word static.
Perform a reset of your superhub.
Setup admin password for router. Do not setup wifi for now.
Connect only your PC to the hub.
Go into the advanced settings of your router and reserve the IP address you want for your devices with specif IP addreses.
Connect your receiver to router. If it was switched off it will autostart the network. Otherwise restart the network. It will now have the IP your reserved for it.
Proceed to port forward as before. Don't forget that the IP ranges is 192.168.0.XXX, The ddwrt ones are 192.168.1.XXX Difference between 1/0

Setup wifi etc on router

I hope you are aware that the wifi is very poor on the S/Hub 1.

Display More

thanks for that mate ill give that ago

Quote from D

ditch the dm get a vu lol

i was thinking that but if it did the same to that i'll be in the same boat lol

Quote from D

could the hub be faulty ?

i dont no mate, every thing els seems to be fine, just the hub is blocking me dream box

i google yesterday virgin super hub blocking dream box the seems theres a few people having the same problem but no1 says how to fix it but the gose back to 2012

Quote from D

my superhub 2 says on bottom what it is

its a superhub 1 mate ive just been on the virgin site

Quote from D

my superhub 2 says on bottom what it is

its dont say mate, just netgear CG3101D and some over numbers on the back of it and SSID, password's and username's

Quote from nano

I cannot understand why if you put your router into modem only mode that it will not allow your PC to access the internet.

All you would need to do is put the hub into modem only mode and then connect your router up as usual. In modem only mode you hub should do just that. It will act purely as a modem and nothing else.

Did you connect your router upto port 1 on the hub. When its in modem only mode only port 1 works. It switches the other 3 off.

What i would suggest is to change the MAC address in your router if it allows you to before reconnecting to the hub. On my old D-Link DIR-615 you could clone the MAC address of your PC or assign it any mac address you liked. That may be the issue if your PC cannot connect to it.

Nano

Display More

ive still got the D-Link DIR-615 router but think its on its way out because the wifi signal is crap now and ive got to restart it all the time, thats why i got virgin out and there give me this shuperhub

Quote from abu baniaz

Rather than disable dhcp, I would suggest you assign IP addresses on router and leave all devices on dhcp. That way the IP will be fixed and assigned by router. There is obviously some conflict.

Are you using Superhub 1 or Superhub 2?

i dont no if its a super hub 1 or 2, its a netgear CG3101D

still no joy, Inspiral TeamViewer and had had ago but still nowt, thanks mate

Quote from master G

Set it back to DHCP.. This will obviously change the ip address, that`s why your clients can`t access the card.. Go into portforwarding settings in the router and change the settings to match the new ip address.. Restart CCcam and all should work. Now turn DHCP off or set a static ip address in the router settings..

will u TeamViewer with me master G, ive been messing about with thing for days now ang getting now were lol

see if u can do it lol

Quote from Inspiral

Your setup has now changed m8
Setup DM in dhcp mode
Or do as I said in post #9

this is what ive just done.... put the dhcp mode on on the dream box reset it and nowt at all worked my shares sending out shop working

so turned the dhcp off and set it back as it was the shares going out worked again and the share coming in started to work then the share coming in went back off but the clines going out are ok

Quote from busman

just quick question is your dhcp on your dm active if not try in on

nor mate master G set it up give it i fixed ip

all was good till i got this superhub

Quote from mckee25

Did you try what was suggested earlier in thread buddy? put the super hub into modem only mode and use your old router attached to it?

yeh mate i tryed how u said that wouldnt even work, i put it in modem only mode and it wouldnt let my pc go on the net lol

is there anyone whos had this problem and can help?

i googled this morning virgin super hub blocking dream box!! and comes up with a few people with the same problem but know one says how to fix it :angry:

Quote from D

let us know how /if it is sorted please

will do mate

Quote from johnunited

what the helll . why Uk have such a poor network providers honesly BT virgin sucks i had the time to use BT VIRGIN AND TALKTALK all of them are **** get disconnecteed every 4 minutes of use..

ive never had a problem with virgin ive been with them for 16 years

its just this super hub i got the over day off them blocking my dream box from receiving the share i get off a mate, tryed tests off over people and there dont work too but sends clines out ok just wont receive

Quote from Inspiral

Might be the superhubs firewall setting
That is stopping the receiver connecting maybe??

ive just turned the superhubs firewall setting off then rebooted me dream box and superhub and still no joy

theres something blocking it :angry: and i bet its just something silly

u couldnt TeamViewer and have a look could u?

Quote from Inspiral

I don't have the so called super-hub m8
I wouldn't expect your image to be a prob as guessing all was ok b4 superhub?

You Could try manually setting your receivers IP
So for eg:- if routers IP is 192.168.0.1 set your receiver as 192.168.0.2 then reboot

yeh mate thats rite all was ok till i got the super hub, master G set up the hub with my receiver

ive just got an over cline test off some1 and that dont work too

its sending info out but seems its not taking info in :angry: