Hi Ten Below.....I tried both setting that you recommended and no service found no signal...unfortunately ....what else do you think should I try..thank you for your patience and support. Regards Vio
Posts by adivio
-
-
Hi Ten Below , thank you very much , I will try and then I'll let you know how far I get, thanks again. regards Vio
Hi adivio, these guides are for Dm800 but the process is exactly the same. Is it just this sat thats not working (more info helps us help you)
-
Hi Linuxsat-support Administrators, Moderators and Members, I'm Vio from Canada, I'm new to Satellites and Receivers and I enjoy your forum like everyone else to learn about it and enjoy this wonderful world using my Satellite Dish.
I just got a VU+Duo Receiver, it has BH image 1.7.1 , 500Gb and Vonets WiFi bridge, I have mounted a 33'' (`85cm) Dish with an 90HH motor and an Ivacom QPH-031 Quad Polar LNB ( circular and Linear), I have dual cabels for both tuners with DiseqC switch 2 in 1, the Motor was seated for Galaxy 19 with another receiver, my location is Long: 80.48 W, Lat: 43.43 N, the details from the receiver which have been used to set up the motor where Frequency 10750, TP frequency 12177, Symbol rate 23000, Polarization V, I try to add Galaxy 19 on Satellites list and set up my Tuner with :Configuration Mode : advanced
Satellite : Galaxy 19
LB : LNB 1
Priority : Auto
LOF : Universal LNB
Voltage Mode : Polarization
Increased voltage : no
Tone mode : Band
DiseqC mode : 1.2
Toneburst : None
Commited DiseqC command: ( I try them all) none, AA, AB..
Fast DiseqC : no
Sequence repeat : no
Command order : default ( commited, toneburst)
Uncomitted DiseqC command : no
DiseqC repeats : no
Longitude : 80.48 W
Latitude : 43.43 N
use USALS : no and I try with yes too
Pozition :001 ( when I seated no for USALS)I will appreciate if anyone can help me with these settings and try to make it work, I am sure somewhere I missed something with my setup. Thank you very much for reading . Best Regards Vio