Posts by tinsat66

  • sunray4 HD800se V2 messaggio di errore

    Good evening everyone.
    I have a hd Sunray4 if v2 sim 2.20.
    Unfortunately, by mistake, I uploaded a wrong picture (it was for DM800SE V2 and not to clone) and Sunray, upon reboot, you are stuck. Now on display, once you turn the decoder, appear in sequence (a few seconds) the following message: "dhcp ... BOOT # 88A" and "dhcp ... *** STOP ***".
    With the decoder (off) connected to the modem-router (DHCP active) and with the decoder connected to the PC (via a USB-microUSB cable, the PC has recognized the decoder immediately and automatically download and install the driver) I tried to flash a new image with the help of "Sunray-FlashUP" but the attempt went empty (I guess that the tool was designed for earlier versions of Sunray4 hd if this does not work, I think ... in the sense that He recognizes the USB port where you connected the decoder but, once you turn the Sunray, the button to make the flash will not fire).
    Always with the Sunray connected to the modem-router via LAN, I also tried to turn it on by pressing the small button back flashUp (I held down until two minutes straight ...), but the display did not appear any IP address, always and only the words: "At flashup mode. dhcp ... *** STOP ***". I also tried to clean the sim and contacts under the slide of sim (on the mainboard), but nothing, always the same result.
    Bottom Line: Managing going modem (192.168.1.1) - State / LAN connections - I noticed that even in this situation, when I connect the decoder to the LAN and turn it on, it is assigned an IP address and still in the "state" is even connected; except that, if the browser I attempt to connect to that IP address I get no response ...
    I do not know what to do ....
    I apologize if I have been too long in descizione of the problem and I thank in advance all those who will help me to solve it.
    Hello everyone.


    - - - Updated - - -


    RISOLTO!
    ho collegato il decoder con altro modem-router a casa di un mio amico e, dopo averlo avviato tenendo il tastino posteriore flashup premuto, mi ha subito restituito sul display un indirizzo IP!!!! A quel punto ho subito caricato l'immagine giusta. Ora anche sul mio modem-router funziona tutto alla perfezione.
    Grazie a tutti....