Hi guys - Just wondered if any one had come across this error - No parse cannot emu error? I did an auto rescan yesterday and now on most (not all) of my 13E channels I get this error. All of my 28.5E channels seem to work fine...
- - - Updated - - -
Looks like the reason is because I'm not picking up all the hot bird channels. Just did a manual scan and only getting around 500 channels... Not sure what's going on.
Hi - Today I setup a new dish for Astra to go alongside my hot bird dish. I had both plugged into my vu+ duo2 and both working fine. I then introduced a 4 way diseqc and did a full rescan, I saw that it scanned all hot bird and then all Astra channels but now only hot bird channels are working, Astra channels are listed but not working. Am I missing a setting on the duo? I have just read that the box should be off when installing the diseqc and I didn't do this, would it cause a problem? I also have 4 inputs on the diseqc, hot bird is plugged in to port 1 and Astra port 4, should I use ports 1 and 2 only? I'm also running the latest black hole. Any help appreciated.
- - - Updated - - -
Managed to work it out. Needed configure port d......
Just found a duplicate cfg file in the etc folder. This may have appeared after I install cccam 2.1.4. There was no cfg created when I installed 2.3.0. The new cfg has lots of info in it, and is much larger in size. Should I copy the clines into this one? If so where abouts in the cfg do I put it?
- - - Updated - - -
Understood. Apologies.
Hi - I've received 4 clines copied them into notepad, saved it as Cccam.cfg and transferred it to the etc folder on my Vu+ Duo2 using DCC. I've also installed and tried Cccam version 2.1.4 and 2.3.0 but when I try any of the channels I'm not getting anything, is there something I'm missing? I've also rescanned and rebooted the box. Using the latest black hole. Any help would be appreciated.
