Hi thanks for the reply
No 11w for scanning it was just an example tbh. i could start at 28.8 use the vu+ to tweek signal from fine movements do five then the box wont find or lock onto anymore sats and i dont know why?
I dont mind scanning i have always done it like that. But i cant understand why u cant use fine movements and save the sats postions and why it says
" warning no LNB using factory defaults"
Hi thanks for the reply
When i had the dish setup the installer said i needed to fine tune the sats to peak them. The problem i have found with catseye one it puts loads of favs in for you i don't use. i would rather have mine I also can get more sats from my location with tweaking if i could get the manual way to work
Hello, I am hoping someone here may help.
Have a VU Uno Running Vix 3.0, i have upgraded my dish to a one meter from 70cm. The dish is fitted to a dark motor.
I paid to have the dish relined by an installer to save time.
I am trying to fine tune the satellites on the Vu box bu having really problems. Before is how i am doing it.
Tuner set to advanced - Satellite 11.w
LNB lnb1
priority auto
lof universal
voltagemode pol
increasd voltage yes
tone mode band
disq 1.2
tone-bust none
committed disqc none
fast disq yes
seq repeat no
command order committed tonebust
uncommiteed dis none
disqec repeats none
use usals no
stored postion 006
Then been going to postion setup
Tune and focus
Predefined transponder
Movment search east/west
Once it has found the transponder, i fine tune it and then save it to the position as in the tuner menu. I wanted to do this to tweak all my sats .
However i have been having problems, i do about 4-5 sats with the above method. Then when i use positioner setup or finding the next satellite one it cant find anything and get no lock. The dish is moving outside.
In the positioner setup i get a message which states " Warning no LNB using factory default settings "
I am really stuck and have been following instructions online and i am still not getting anywhere
