I have already put different numbers in the groups, as I said;
In oscam.dvbapi I put P: 0100:005221 and this way it doesn't read the card so it works if I put M: 1814 0100;
It's a configuration issue....
I have already put different numbers in the groups, as I said;
In oscam.dvbapi I put P: 0100:005221 and this way it doesn't read the card so it works if I put M: 1814 0100;
It's a configuration issue....
The real card has group 1,2,3,4,5, but the lines have group 1.
I've already put in Caid 1814, and changed oscam.dvbapi to Priority instead of Mapping. did not work
Goodnight
I use oscam-emu in a f4 formuler, with the card meo caid 0100 and I have lines already with the caid 1814. I have the mapping in dvbapi M: 1814 0100:005221, which reads the card but does not read the lines (if it reads it takes a while to give and starts with several stops), if deleting the mapping does the opposite, it reads the lines (no problem) it doesn't read the card. Does it assume that there is some configuration that is not correct (I think), or is there no possibility of putting everything to work at the same time?
I've tried several settings that I googled and nothing. I thank you in advance for any help that may appear.
yes, and the stream for this channel should be http://0.0.0.0.9999.abertis/pid702
reboot once your receiver, and show me what oscam.log says when you are in the channel...
sim, corrija, salve e reinicie o oscam.
Além disso, qual canal você está tentando assistir? aquele que é direto para a lista de satélites? ou o outro nos favoritos (que é o stream interno)?
I saved and restarted oscam, but nothing!
The channels are via the internal stream (favorites list).
Is it normal for the stream to be 0.0.0.0 ....?
open oscam webif , go to config/stream relay ... and enable/add the above
is where i put it? If it doesn't work ... it's hard for me. thanks for your patience :(
enable stream relay in oscam config, and add provider FFFE...
Hello, sorry to ask and my ignorance, where I enable and configure oscam, which file. Thank you
Hello
the steps I took was what mebr jobedir indicates:
1. Send the attached channel list ( use Dreamboxedit )
2. Install astra-sm by telnet:
opkg update
opkg install astra-sm
Reboot
3. Put the file "abertis" in etc / astra / script
Give permissions 755
(Use an appropriate Abertis file , attached for the arm and mips receivers)
4. Put the astra.conf file in / etc / astra.
Permissions 755
5. Copy the sysctl.conf file to / etc
6. Correct keys in softcamKey
the result is what is in the attached image
which image are you using, and which are the steps that you have done... one by one to find what is missing
Hello I'm using openpli 8 and Oscam-emu. Advise another?
Hello I've already follow those steps. I don't know what I'm doing wrong, but the channels don't work. What image do you suggest ?
Hello
only octagon can see the Abertis T2MI Channels on Hispasat?
I have a Gigablue UHD 4k already try to place the described files and the image is black with key detection information. Is there a possibility in this gigablue?
Hello
I have a gigablue x3, and I use the openrsi image based on the openpli, of which I am satisfied, but there is no update already and in openpli there is nothing for gigablue x3, what image do they recommend?
Thank you .:/:/