Posts by roch71

  • NEED HELP IN GI S8120

    The device boot normal but my problem nothing display in TV

    Is this problem hardware or software

    I connect GI S8120 with program SSCOM (using câble RS232)

    Please explain to me if this data is good normal



    Board: STx7111-Mboard (MB618) [32-bit mode]

    info: Disregarding any EPLD



    U-Boot 1.3.1-g057e7c28 (Oct 21 2011 - 09:58:11) - stm23_0043 - YW 1.0.021 Rel


    DRAM: 128 MiB

    NOR: 8 MiB

    NAND: 512 MiB

    In: serial

    Out: serial

    Err: serial

    IdentID : 09 00 0b 00 00 ab 88

    Hit ESC to stop autoboot: 3 2 1 0

    ## Booting image at a0080000 ...

    Image Name: Kernel-Ramdisk-Image

    Image Type: SuperH Linux Multi-File Image (gzip compressed)

    Data Size: 5867343 Bytes = 5.6 MiB

    Load Address: 80800000

    Entry Point: 80801000

    Contents:

    Image 0: 2970211 Bytes = 2.8 MiB

    Image 1: 2897119 Bytes = 2.8 MiB

    Verifying Checksum ... OK

    Uncompressing Multi-File Image ... OK

    found phy at addres = 1

    stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1

    stb_id = 90b00ab88

    Loading Ramdisk to 80d3c000, length 002c34df ... OK


    Starting kernel console=ttyAS1,115200 rw ramdisk_size=6144 init=/linuxrc root=/dev/ram0 ip=192.168.0.69:192.168.3.119:192.168.3.1:255.255.0.0:lh:eth0:off stmmaceth=msglvl:0,phyaddr:1,watchdog:5000 bigphysarea=4000 nwhwconf=device:eth0,hwaddr:24:00:0B:00:AB:88 Manufacture=Spark-Project STB_ID=09:00:0B:00:00:AB:88 - 0x0053d000 - 2897119 ...


    [MAIN] init finish,errCod

  • NEED HELP IN GI S8120

    the cable HDMI it is work good with other receiver

    my spark GI S8120 with new remote control

    I try test enigma image with open atv 6.4 the device stop in boot

  • NEED HELP IN GI S8120

    hello

    thank you very mutch

    I tested the two images with cisco, the process went through successfully, but the same problem

    The device boots up normally without a picture on the TV

    Is there another solution, thank you

  • NEED HELP IN GI S8120

    It boots normally until the clock appears on the screen but there is no picture on the TV

    I passed some updates to him via usb to restore it to factory settings, but to no avail, the same problem, there is no picture on the TV

    I tried to find ip address via DCC, but it is not recognized even though it is connected to the network

    I passed him an image of open atv 6.4 in enigma The process passed successfully but it remains stuck on BOOT

    Please help me to find a solution to this problem, thank you very much