I'm looking for the IR code for the VU+ remote. To program it into a bang & olufsen system. Allowing it to take control of the IR side.
Can anyone shed light on it. Thanks
Posts by jenniferwhite
-
-
Had this problem on several F5s. they seem to have ultra sensitive tuners in them. Some will fail a blinsd scan on a few requencies, and show "no signal" on some channels. Yet put it on anoter LNB or feed from the same LNB and it works fine. Go figure
-
Does or has anyone ever measured how much (approx) data is used when watching sly Uk channels with mgcam. Is it 10Mb's, 100Mb's, Gb's, 10Gb's?
I know its all dependent on how many non freeview channels you watch, but would be interesting to find out.
-
Tried on VU Duo CLONE BH 1.7.4
installed folder via DCC
Installed fine, few twists when using. I get the 0.00 time issue as well, but returning to the program list and tryng a 2nd or 3rd time, its usually works.
So thanks to the guys for their hard work
-
Tested on Clone Duo BH 1.7.4
Installed folder via DCC
Working fine with a few funny twists
sometimes when your first play a program nothing happens, the program time stays at 0.00, just stop and select yes to return to list, then start again. usualy works 2nd or 3rd go.
thanks to the guys who wrote it
