Posts by perlik
-
-
When I activate the rescue mode, nothing is displayed on the screen. The receiver worked by the customer for 4 years without any problems.
I checked all capacitors but they seem fine.
-
Your RJ45 port is working or was it burnt ?
TS
I don´t understand. RJ45 works on my computer but not on DM. I have tried to connect PC directly to DM and via modem too, buy unsuccessfully. From my log address: 192.168.0.219
-
Unfortunately, it works only serial comunications (com port). It isn´t possible write text there (maybe I don´t know how).
P.
-
Thanks for quickly response,
but I don´t know how. Is not possible change DM to rescue mode via front button, telnet doesn´t work, only serial via putty
-
Hello Dear,
Can someone help me? I have the similar problem like above. But it works only serial communications, no internet access, When I turn on my DM short blink blue and then red colour appear. Lan connectors is shining only yellow led.
My log bellow:
CI box detected
card if inited
Enabling NAND flash at CS2: A5U4GA31ATS(DEVICE ID=0xC8DC9095), ECC Level=4, Spar e Area Size=16
MACRONIX SPI flash detected: Size = 16MB, Sector Size 4096, Page Size 256
CPU speed: 751MHz
DDR Frequency: 1061 MHz
DDR Mode: DDR3
Total memory(MEMC 0): 512MB
MEMC 0 DDR Width: 16
Boot Device: SPI
Total flash: 16MB
RTS VERSION: rts_hevc10_1067
ETH0_PHY: INT
ETH0_MDIO_MODE: 1
ETH0_SPEED: 100
ETH0_PHYADDR: 1
DM init finalization
yxml: processing file of 131072 bytes... succeeded!
no file loaded, create xml restoring default xml
loaded network params of: DHCP, 192.168.0.219, 255.255.255.0, 192.168.0.1
[1] type 3, dev nandflash0.kernel, loader elf, filesys raw, file , options
[2] type 3, dev flash0.kernel, loader elf, filesys raw, file , options
[3] type 1, dev eth0, loader elf, filesys tftp, file , options bmem=192M@64M con sole=ttyS0,1000000 root=/dev/nfs ip=dhcp
added 3 sources to autoboot list
init fp
Thanks for your help
