Dear Members
Hear are simple steps to configure extra images on Spark7162 & Spark7111 receivers
First prepare usb
On Spark side of receiver insert usb on back of receiver and through remote goto:
1 - Menu
2 - System
3 - PVR/HDD setting
4 - HDD format
5 - Now press on green button of remote (partition manager)
6 - Now press on yellow button of remote (Delete)
7 - Now press on green (New)
8 - On size (insert 1000 mb) and confirm (repeat it for making other partitions) Note: through this method on Spark you can make only 4 partitions
9 - Now press red button on remote (Apply) to save these settings
.
Now format these partition on Ext3
1- Now select any partition and press blue button on remote (Format Disk)
2 - Now select Ext3 and press ok (repeat it for other partitions)
3 - Now reboot your receiver to enigma2 mode (Here is simple method: system_ basic setting_ factory default and then press on remote within 2 seconds: EPG 5 2 1 0)
Or watch this video for above steps
usb setup for extra images.mov
.
I have configured these images on OpenPLi-7. You can use image of your choice
Here are simple steps to install extra images on Spark receiver.
1- Install Image Manager
2- Reboot receiver
3- Shift your extra images in USB through DCC or any FTP App (each image should be in separate folder and rename folders like: Pure2, OpenVision, OpenPLi etc) (Note: always save images in last partition)
Now installation of images
1- Goto plugins
2- Open Image Manager
3- Press on remote right arrow to Select Mode: Installing
4- Select target partition: sda1 where you want this image to be installed
5- Select install mode: repacking
6- Press Ok button on remote
7- Select the image to install and press OK Button
Here's Image Manager ipk plugin
enigma2-plugin-extensions-imagemanager_2.5.5_sh4.rar
Pictorial Guide
1f777fc5b.jpg600bfaa368094baba3.jpg3bb9fdfe6e.jpg