Is it possible your dish is actually pointing at Astra 19.2?
Did you get a picture when you tested with you sly box?
Try doing a quick scan of astra 19.2E
Yes as i have sky+Hd and get a very strong signal on both feeds for it.
Is it possible your dish is actually pointing at Astra 19.2?
Did you get a picture when you tested with you sly box?
Try doing a quick scan of astra 19.2E
Yes as i have sky+Hd and get a very strong signal on both feeds for it.
i have them settinsg yes....i go into satfinder and then set in manually or predefined and i get signal on 28.2e
i then go out of that page and go back and its shanged to something else astra 19.3 or something..how do i make sure it locks onto the 28.2 one?
here are some photos taken on my phone:
I have the pre-installed image on which i belive is gemi 5.1 but on the main screen it says enigma2 loading in the bottom left is this normal? shall i install a new image?
i have given up for tonite it was doing my nut in lol!
So am going to have another go tomorrow afternoon
Thanks for all your help
no lol
do u think i should change my image?
added them with dreamboxedit
they are now on the box but i still have nothing from any channels do i now edit the cccam.cfg with my cline
ok thanks i will try that instead
checked my signal strength and all is above 95%
Yes my dish i aligned ok as i tested on my sky
Load one of these onto the box and save yourself the need to scan
Enigma 2 Channel List
If you are looking for 28e only then flipflop or silvefox are both good.
What image will these work on? as my box is on the default gemini i belive and says enigma2 loading in the left corner
i have cancelled and done a manual scan
10714H changed to DVB-S QPSK 10729V / 22000 5/6
straight away is that correct? and is scanning through other ranges..how long should a normal scan take?
will give it a go now...my scan is 35% done and no channels been found so far do i cancel that and do as you ask?
Hi
I have a clone dm800 and struggled at start to get a signal at all from satelite..then followed a few setting guides and had 99% signal..so i went to auto scan for channels and its only upto 17% and has no service as of yet and has been on about 15 mins.
Is this normal? i am on 28.2e for sky uk
How long should it take and when should i expect to get any services percentage wise!
Just dont want to wait for scan to finish when i should have had some services by now i would have hoped.
Thanks
Andy