Success: I can see your service on 82.29.*****on port (16000)
Your ISP is not blocking port 16000
Posts by junger
-
-
Sorry, the host dyndns shows a green circle with a tick, underneath it says status good, i will download the cs studio. I am using atenda wirless router, could it be any settings in the router/
-
hi all
i have setup my cccam 2.1.4 with 3 test flines, i am using my dm800hd with boxkey I then setup my cccam 2.1.4 config.cfg. I sent 3 flines to m8's to try and i requested a share on this site.
Dismal Results: They cannot see my server so I looked at cccam info page and no clients are shown, there is servers thatfor which i have a cline showing and the cline is active on my dm.
When I ran port forward, it reports a green light on TCP and says that my port is open on another device (i assume that to be my dm), on UPC is says it can ping my router, but the port is not open or reachable,
Any ideas to resolve this please so that I can share?
:blabla: -
can anyone help, I have created an fline, given cline but the client say my server is off line, i have port forwarded the port, turned off firewalls, PF says another devise is accessible via TCP, Help Please
-
thanks for all your help Ten Below, look forward to being a sensible and posotive poster
-
Thanks master G, That was the problem, the other suggestions were obviously for a different image. Now I can develop a bit more.Many thanks, incidently, i installed the 214, how does that fair against the 22!?.
All channels clearing again thanks -
Hi All
My Gemini 2 Niablosat Bh crashed a couple of days ago, when i re-installed it it became apparent that the servers were not hosting the Cccam 2.1.4. so I tried to manually transfer via ftp and dcc to temp, no joy, though it was there in the dm dowloads it did not appear in the cam section, i tried to download tunisiasat addons but with the same problem. I am pulling my hair out because i think i am doing it right but am going round in circles. Can anyone enlighten me please?
Thanks
Junger
