KINDLY SUGGEST ME THAT THERE IS ANY POSSIBILITY THAT I COULD INSTALL ZEGMMA H9S SE FIRMWARE ON ZEGMMA H9S WITH mSD CARD. I THINK BOTH THE BOXES ARE SAME HARDWARE EXCEPT FLASH SIZE i.e H9S SE (16GB EMMC FLASH) & H9S (256MB NAND FLASH).
Posts by ay_248
-
-
Enter recovery mode firmware
Turn off the box. On the remote control, hold down any button and hold it continuously.
Turn on the box and wait for the entrance to the recovery.
Thanks teak-won-do
I have Zegmma H9S stuck on White light, this problem created last year. I tried all the suggested method to recovery it but no one work. Then I read your post, proceed as suggested, hurray and i recovered my box.
-
-
I have connected H9S with PL2303 Cable with PC,
When I start box the terminal in HiTool shows the followings:
Bootrom start
Boot Media: NAND
No more information and it is also not accepting any command from terminal window.
Is it Hardware or software issue.
Any other steps that I can follow to boot it up?
-
I already mentioned that box not detecting firmware files from USB 0.2 port, I want to know the process you have adopted to flashed the fastboot.
Did you sent any command through RS232 to the box for changing the boot order in NAND FLASH.
-
Flashing fastboot manually from USB pendrive:fatload usb 0:1 0x1000000 fastboot.bin 0x60000
nand erase 0x0 0x60000nand write 0x1000000 0x0 0x60000
Kind share details, how can i flash boot from pendrive?. As I have tried different software versions with different pendrive but box did not read the firmware from pendrive.
-
Once had this kind issue in my machine .
I removed sd card and flashed the box with openpli 6.2 image
I used the original Kingston 4gb usb (formatted 32) . later on I found out sd card was faulty. if u have already tried it . then forget my post .
Thanks dear, I will flash my box as you advised.
-
Thanks dears,
I will try to upload different firmware. Previously i am using Pure2 with Micro SD as expanded flash.
Can I use this
zgemmah9combo-PurE2-6.5-20201124_recovery_emmc.zip to recover, because no recovery image is available for Zegmma H9S.
-
MY ZEGMMA H9S BOX STUCK ON BOOT WITH WHITE LIGHT AND WHEN I POWER IT ON, IT ONLY SHOWING WHITE LIGHT NO RED LIGHT. WHEN I TRY TO RE-FLASH IT, IT DID NOT PICK THE FIRMWARE FROM USB.:shocking:
ANYONE SUGGEST ME SOME KIND OF SOLUTION? -
KINDLY SUGGEST ME WHICH CAM (OSCAME , NCAME, GCAME) IS BEST WORK FOR POWERVU CHANNELS ASIASAT 7.
AND SHARE WITH WORKING POWERVU CONFIG.
MY STB IS ZGEMMA H9S ARMV7