Posts by ratkins

hi mate i use openpli on an xtrend box i connect to the box via dcc mines an enigma 2 box so if yours is make sure you use dcc e2 then you go into ftp open up your cccam and edit the line that is to say put your c line in. save and exit and it should work, but you might need to reboot your box. also do you have a cccam loaded.

hi
B: 06
been working fine until about two days ago

hi i have 138 running fine on an openpli image, just recently every now and again the picture freezes and flickers. the audio carries on as normal. it might only do it twice a day but annoying. its only happened while commercials are on wierd!!!!!!!!
i flick over the channel and all fine.
anyone come across this before or any ideas

hi guys been running on 138 now for quite a few days and would only recommend using this over CCcam anytime.

only with all the support. THANKS EVERYONE

ok reflashed image reloaded tspanel did changes as set out in this thread.
and guess what it WORKS .
a big thanks to everbody who helped. and ofcourse there patience.

ok im pretty new to this and in the first post it just said change 06 no mention off brackets until later on. i then changed the number in the brackets. but this didnt work . neither did changing the number to 33 as mentioned in another posts.
but its still not working.
reading the post above from robbin he said he put mgcamdin usr/emu i downloaded from TSpanel does this put it in the right place??

i use cats eyes list one of the best

by the way still not working.
how do i delete 138 from tspanel so i can reload

ok i changed G to 33 i did notice on L it had a web ip address after it . it that correct?

how do i remove the mgcamd via TSpanel or DCC

only other cam i have is cccam i turned that of.
i will remove the cam and see what happens.
was it ok the edit the line in the keys folder and not ftp it across. i used dcc for this.

My box is xtrend 9500
i loaded TSpanel and downloaded 1.38 mgcam also 135a as suggested in another post
i input my line in usr-keys went form N: to CWS =
i input the newcamd list supplied in an earlier post then i edited the line on the box and saved the changes.
i have mg cfg file and newcamd list
mgcam is enabled ie it has a green dot next to it.
any thoughts would be appreciated.

tried that but still not connecting.

ok thanks i will change that . i took the # away from the line with 06.
will update later.

the config file was mg cfg that was the right place??

ok i took the # away from infront off 06 no joy and tried auto no good i did restart enigma each time should i have done a full restart???

no one with any ideas

tried 135a no joy
i dont know where im going wrong its driving me crazy
done full restart after installing

thanks will try that.
do i need to turn off the ccam lines?