Posts by BigManTom

Hello,
I have installed the 1.8 version on my VU+ Uno 4K Se with OpenATV 7.4 NEW (uninstalled the old 1.6) and after restarting
I have Vavoo under Plugins, but it just won't start!
I had all versions so far and they were all OK (until recently)!
I don't understand...

Hi, very nice Work...

Is there a possibility of EPG source???

BIG THX

BigManTom®

Quote from digitronko

BigManTom i had the same problem. I've found out that Stream Relay was set to disabled. After i have set it manually to enabled, it works.

Setting can be found via web interface - config - stream relay - mode.

This is a bit weird because i have this settings in my .conf file

[streamrelay]

stream_relay_enabled = 1

stream_ecm_delay = 5

stream_relay_ctab = 098D,0960,0961,0963

Hope it helps

Display More

THX i will try...

Quote from digitronko

BigManTom i had the same problem. I've found out that Stream Relay was set to disabled. After i have set it manually to enabled, it works.

Setting can be found via web interface - config - stream relay - mode.

This is a bit weird because i have this settings in my .conf file

[streamrelay]

stream_relay_enabled = 1

stream_ecm_delay = 5

stream_relay_ctab = 098D,0960,0961,0963

Hope it helps

Display More

YES!!! This was the Problem!!! THX for your TIP!!! ;)

Thanks for all the tips, I'm not a complete beginner, I know how to use the binary! I have always used all Oscam from Mohamed_OS and have always had very good experiences! But this 11748 version doesn't work for the first time! Today I installed the 11748 version compiled by Kitte888 and everything works GREAT! Thanks for your help

I updated today to this 11748 version (Mohamed_OS), but unfortunately no one Sky DE Icam channel works for me!

I have used until now 11734 (also Mohamed_OS), without any problems! Also all icam Sky DE have worked! How come?

Do I have to reset something?

My Receiver is Vu+Uno4K SE (OATV 7.3)

THX for any HELP