why it works in "manual" is behond me... but finally it works.
Posts by powervr
-
-
I found the problem... :D
it works... don't know why it doesn't work still but it works...
So... I had another receiver connected with the simpler of the dual 2 way sat pass (not an switch) when I disconnected it from the electricity main... finaly it works... :D
So I have just to buy an better switch to disconnect the other receiver when edision is on.
ha could be just an mqtt signal (is that possible?) to an zigbee switch to kill the other receiver when edision is on... ;) I have also homeassistant on my home.
-
this guy used this ... I have to put the same image...
-
https://www.sat-universe.com/showthread.php?t=316615
The same problem, I wonder if this is related with the cable like he said...:D I wonder... the cable and it worked in "manual" haha... not probably.
just bugs... for some reason it started to work again in his case.
-
I find weird this to happen... the most strange is that it works... could be when you change the channel it send the diseq without tension, maybe older version (slower) could be atainable or if I make the code ... I know some C ++ ... not that much, but this could be the thing to make me enter the scene... obviously motorised antena are not the "norm" anymore... I tried a lot of images, but I have to turn into older ones still... :D
6.5 is buggy as hell in edision io 4k plus , but I remember I get it to work with some setting enabled (repition diseq) etc... the problem is I can't make it to work again... some weird setting? :D I lost more than 20 hours on this... more than regulating the motorised antena... (without bussola) but with an signal finder... :D
-
Could be the receiver not waiting enough to have tension and sending the diseq command before the channel changing? just me thinking...
-
Hello everyone.
I just tried everything... in the position menu, I can ge it to move... ie it does GOTO X everything even memorising the position for diseq 1.2 (no usals) but when I edit the satelite with diseqc (with the correct position it doesn't move... weird... so it works everything ok in the menu position move, etc... when I change to that satelite nothing happens... weird... I just tried everything and many firmware.... after... no luck.The motor works, do the diseqc and stuff... even the receiver... but when I ask for it to move outside thise menu nothing happens... :frown: