Display MoreDisplay MoreDisplay MoreHello All
Installed version 1.1.4 on a Zgemma H9.2H SE running openpli 8.1 (couldn't install version 1.1.6).
The very first time I run the plugin and started openvpn it conected fine to my vpn. The proble is, after restarting my enigma receiver, I could not access internet anymore. My receiver receives no IP (if HDCP is enable) and if I set DHCP to off it wont accept the imputed manual IP. Doing a network test shows that I have no IP and am not connected to the internet.
More, if I try to change my network configuration (I have bothe LAN an wifi interfaces) my receiver crashes.
I had to re-install OpenPli and started everything from the begenning, with the same result.
If I run OpenSpa instead of OpenPli it will run OK!
So, is there any way I can set it properly in a OpnenPli image?
Salomao
Hi I have vpnmanager working here on Openpli 7.3...with version 1.14 . After 3 nights of pulling my hair out I finally done it...kinda lost what I done but I can trace my tracks for you if you still havn't sorted yours out.
Hi Did you have a problem after installing the plugin saying"No module named subprocess" ? I already have v.1.1.4 running on dreambox 800SE but due to an error I needed to re-install the image again and I never be able to install the plugin
No, I didn't get any error message. I am able to install and run the plugin for the first time, but then my network configuration wont work anymore.
