Posts by Mayllopl

  • Oscam internal card setup conax

    Quote from master G
    Quote from .atari.

    I think this card with caid 0B01 are 13E / NC+ polish provider

    Boxkeys and rsakeys will definitely be required then. oscam isn`t plug n play the same as the Crypobox would be. It probably has a Conax embedded card reader.

    Yes, it is polish provider "Telewiza na karte" prepaid card. This card worked for me in oscam 7 and more years ago.

    When I had Newnigma2 , i had few years break with tvsat hobby because lived in city center and not have sat dish.

    Now back to outside city center and back to hobby. Now I installed new OpenPLi 8.1 Japhar on my DM and tried configured again conax card in DM8000.

    This card never not need RSA and BOYKEY to work in my DM in past. I have also Dragon CAM CI and also my DM not see this CAM with card.

    That for shure something is bad configured in Oscam in my receiver.

  • Oscam internal card setup conax

    Hello guys

    I refresh this topic. Have same problem right now with my conax old card. Of course card is active, checked on other receiver.

    I have DM8000 OpenPLi 8.1 Japhar with Oscam. master G I created exactly same files to Oscam from your post here, but my card not is visible in any socket in my DM8000. When I login to Oscam by IP:xxxx i see when put card "NEEDINIT" or later ERROR. Can't find any solution to fix it. It is old card version.Any advice ? Of course my Oscam working perfect in sharing etc. Only problem is with conax card.

  • dreambox 8000 + gets stuck

    Quote from maho33

    I tried many different ones and it's the same on all images, isn't it wrong on all of them? it works a little better on openvision but the box does not find the module

    If you have problem with all images , that for shure problem is somewhere with hardware box...

  • dreambox 8000 + gets stuck

    Firstly check voltage by multimetr. If battery will be damage, need very softly remove by very small screwdriver with touch very softtly with soldering iron. I installed my new batter on short slime wires and protect by insulating tape.

  • dreambox 8000 + gets stuck

    You can also check batter on board by multimetr how voltage is. My batter was finished (0,3V) showed) and had problems with self restarting of my DM. After replace new battery DM start working very stable.

  • DM8k and Diabllo CI Cam

    Hi guys

    I use DM8000 with OpenPli 8.1 Japhar , I found few days ago in some my r box Diablo CAM. When I put to my DM8k , my DM not see it , I tested in all 4 slots, CAM 100% working because when put to Cryptobox 650 is visible and work. Any advice why DM8000 now see it ?

    Regards