Hi fingersd
I have removed the eprom chip programmed it with your dump (thanks) and the bricked box is working again.
Posts by targus
-
-
Hi Kredka74
I am very well tnx, how are you?
But my Vu+ duo still not working i cannnot make a connection with my box do you have any suggestion.targus
-
Hi Albert
Thanks for all your work i had seen that it was the wrong pin, the usb and rs232 are dead but i think you can be right that i cannot connect because the bootloader might be ok i bought
the box with the problem just like you and the c807 was replaced also no i am out of ideas agian much thanks for your help.Gr
Targus -
Hi Albert
I know the drop down box but he always jumps back to a0 by the way in picture there is also no fpga tab
Gr
Targus
-
Hi Albert
Also tried but no connection i see in vu.pdf step 9 within chips another tab fpga and a revision b0 instead ao, i have only tab bcm97335 and version a0. may be another version of bcm97335 ? what do you really have my version or the fpga b0 version?
Gr Targus
Targus
-
Hi Albert
I used the same cypress board and i bought it april this year and the only diffrence was i had the jumper closed but after reading vu.pdf i opened the jumper but still no connection i have tried with connection 1 3.3 volt disconnected but with no luck .
On pin 1 2 3 is 3.3 volt when duo is disconnected from cypress so there is life in the duo. The only thing i can think of is a driver issue i have had a lot of problems with the broadcom test adapter(unitialize)Gr. Targus
-
Hi aevegroen
Thanks for your explanation of the jtag i'm trying to do it for months to get a connection between my duo and xp, win7 and with different pc's but no success do you have the golden tip for me?
-
Hi Mick
Can you explain in detail what are the connections from vu plus duo 2 generic FX2LP USB2.0 chip tnx in advance.
-
The answer no!
-
hello do you see the on or boot light on the box.
when you don't anything than perhaps it is the same problem in the psu
NO JTAG at this moment. -
I see that my posts have disappeared but i am still interested in how to jtag an openbox
S9 i have solved my problem it was a defective ld7550bbn in the psu.