Cooltvguide is nice but slower compared to Graphical Multi EPG
Posts by jackhulk
-
-
Thanks cazuela, but the picon are already in the correct folder as they show up on the info screen, but not in EPG. As said I believe there is a modded version of this EPG as the picon appears in OpenRSI 3.0 EPG which states it's the same version 'Graphical Multi EPG'. Perhaps the OpenRSI team modded it.
-
Hi John.
Unfortunately I didn't get this fixed. OpenRSI 3.0 has Graphical Multi EPG where the picon as shown. I think this must be a modded version, as while the OpenRSI 2.1 also has Graphical Multi EPG, the picon are not shown.
-
Hello
I have AZBox Prem+ running OpenRSI 2.1. I've installed picons from lunuxsat-support via TSpanel, and while they show up in the info panel when zapping, they are not present on Graphical Multi EPG.
Any idea what could be the problem please?
Thank you
-
Hi italiano1229
I installed OpenRSI myself yesterday and had the same problem. I managed to solve the problem before I saw replies to my help request post on OpenRSI forum, which gave a very good tutorial by antosat...
Get rti core 1.7 there is a patch bin file under officialtoE2 directory, then follow the below...
TUTORIAL: Official Firmware -> Enigma 2
1. Unpack archive, and copy file patch.bin to USB Memory stick formatted in FAT322. Plug-in USB Memory stick in AZBox and turn it ON
3. Choose update from USB
4. Wait that procedure is finished and that on VFD Display You get message Rescue Mode with an IP address, remove USB.
5. Start application called AzUP 2.2.7
6. Enter IP address which is shown on VFD Display of AZBox HD, Device select DOM, FS choose EXT3, Advanced options check two options. For more info look at picture from the OpenRSI tutorial.
7. Press GO! button under Install E2/Kernel , then it will ask You for patch.e2 file which is located in folder which You extracted from downloaded Enigma2 archive, choose it and press OK, after that wait until You get message from AzUP. After first restart receiver will go again to rescue, so restart it once more by long press Power button on remote control or by switching it off and turning on.
Hope that helps :)
