Posts by colesy72

Sorry if this has been covered, but I have read the other posts and still struggling a bit.

I am pretty good on the VU+ boxes but must be missing the trick with the Zgemma S2.

I have put the IPK file into the temp folder (Using DCC) for Enigma2 and gone into software box, downloaded it, but don't seem to be able to find it on the box.
It was an older version of CCam but wouldn't have though that would have mattered.

Other boxes you would press the blue button on remote and that would take you to the Cams. Where you can select and restart etc.

So the question is, where do you access the Cams from the remote?

I have tried OpenATV and now on Opendroid, and had the same issue with both.
Never used a MGCamd, but was hoping to get this one going before I look into the next.

Any pointers would be much appreciated.

thank you for the reply.
Found it to be the USB, changed to a different one and put an image on it, and it worked straight away.

Working through the rest!

I have bought a zgemma and it is stuck booting up, runs through the numbers - 00 - all the way up to 99 and then back again.

Doesn't seem to allow me to put another image on with the usb, but is continually stuck as above. I have tried a bootlaoder on the usb as well and still nothing.

There is a picture on the screen and the circle is spinning as if it is working but is continually stuck in the loop on the box display.

Turned off for an hour and still does it.

Any ideas much appreciated.

Thanks

Colesy