Posts by blade2008

so LNB 1 is Tuner A? and LNB 2 input is Tuner B, right?
I have done all this but its says port a: not connected and port b: not connected after searching for signals on 28.2 and 19.2

Hi,

I just got my new solo2 and flashed it with Ten Below's backup image OpenVIX-3.0.665. When I now configure any satellite it gives me no signal or nothing connected on the tuner. Have tried so many different configurations but no luck. I have a DiseCq switch with 19.2 and 28.2 and the image loaded a channelist of all the 28.2 channels. But no picture and also when I configure the tuner nothing. I am wondering if the tuner is defect. The switch is connected to LNB 1 input ( I think that is tuner A). I hope somebody can help me. Oh yeah I did not try hooked up my dish when the original firmware was on it. So cannot say if its really the tuner or the backup image which is giving me no sat signal at all.

Thanks for the replies and help in advance.

blade