Posts by fatlad

  • rytek sly uk

    Hi gang


    Can someone explain how i can download rytek sly uk from my dm800 been trying for hours to find it also using the pli image.


    Many thanks

  • Which folder for xml file on eagle ?

    installed xml file to var/etc rebooted the box but still cannot find astra 2a/2b/2d also tried the flipflop using dreamset got all the channels but could not view any channels not even fta.


    so if someone can point me in the right direction i would be grateful.


    cheers

  • eagle box problem

    Thanks Ten, can you suggest an alternative image or is there an updated pli image its my son who has been using the box and i don't think he would know how to mess with the menus.

  • eagle box problem

    Hi gang


    one of my eagle boxs keeps dying on me round about every month this is the third time now.


    First of all it freezes so i reboot it, the box comes on but the screen blank no startup screen (pli jade green) so i reflash it works fine for 4 - 5 weeks then back to square one. Has anybody had this problem before or does the box need returning as it is still under warrenty.


    Many thanks

  • mini dish

    Hi Everyone


    Replacing a mini dish and the Lnb skew is -12.9 but the markings on the dish are 1 to 5 can someone point me in the right direction to achieve the skew setting.


    Many Thanks

  • How to force updates to your sly card

    Hi everyone found this on another Forum


    This is to force Entitlements to your sly card


    You don't have to wait for an Update you can force an Update, Place the card into the Sky Receiver and follow.


    1) Locate the button on the front of the Receiver, named "Back Up".


    2) Press and hold down the "Back Up" button...


    3) WHILE HOLDING IT DOWN, disconnect then reconnect the power to the receiver (do not release the back-up button yet).


    4) About 20 seconds after reconnecting power, all four coloured lights will illuminate on the front of the receiver.
    If the TV is switched to Sky a message will also appear on screen.. "Updating System Software".


    5) Only after the four lights illuminate and the message appears should you release the back-up button.



    6) After about 10 minutes the reciever will return to "standby" (ie. red LED only).


    7. Leave the receiver in standby for 1 minute as it carries out a self check.


    8). Switch receiver out of standby (green LED illuminates).


    9) The receiver will take a few minutes "Searching For Listings".


    This will update the firmware of the receiver and any card updates you have missed.


    Hope this helps
    Cheers

  • Eagle Box

    Hi


    How can i tell if these images are ok for my eagle and if i flash them it wont knacker the box up.


    Darkstar vII EMU 2.2.1s


    Commando-12-DM500s-neutrino


    Many thanks

  • something strange

    Quick update lads


    Everything fine now with vu and dm800 had them running all yesterday with no problems big thanks master G, Ten Below and everyone who gave me a lot of advise.


    The problem was as Ten said in post 5 put the smartcard line in the vu cccam.cfg which sorted it.


    Once again many thanks to everyone