I think that one of them is good
Posts by niosi
-
-
-
ciao, non conosco il tuo decoder, ma ho letto delle recenzioni, è enigma2 DMIPS dovrebbe essere questa quella adatta al tuo box.
-
if its not arm processor4k use this one: OE2.0,OE2.2,OE2.5 O.E.
-
hi, its depends from the receiver, not from image
-
dear, I put in attachment an ipk file for your image. The config directory must be /etc or /etc/tuxbox/config (I dont use the image and I'm not sure of the dir)
after you have installed the ipk you can put the last oscam 11398 and give it 755 permission
-
Thanks for the information. Please advice me where can I find (Thread) future updates of this Oscam in this forum. PowerVu needs frequent upgrade of Oscam.
hi,
this is the right thread,
all the best
-
here is the ipk for your box
-
put the file after you have extrated the .ipk file from rar in /tmp
the on your box you can install it manually. So you find the binary in \usr\softcams\ and he config files in /etc/tuxbox/config.
After all you can replace the binary with the last one remaning it "oscam" with permission 755
-
sorry, I dont check it,
what image have you on board?
-
-
this is the oscam for Vu_4k stb
in attachment you find olso the last softcam
the conf_dir is /etc/tuxbox/config
greetings
-
hi, here are 2 oscam fo sh receivers. I dont know what stb you have, so I complile both. I put in attachment the complete configuration and the last softcam.
put the oscam binary in /var/emu (rename the bin "oscam" and give it permission 755)
put the config and softcam in /var/keys
-
hi, please go here an leave your introduction.
this is the oscam_emu for tsi images. The directory for the config is /etc/tuxbox/config.
put in the same dir also the softcam.key
greetings
-
put this ipk and then change the binary, that you find in "/usr/bin" (permission 755), with that one you can find here: latest oscam
-
hi kpblxa
ok, download this attachment and put, after you have extract the .ipk file, in /tmp.
After you can run manula installation directly from the box or, if you want by telnet, send the command from the promp "cd /tmp" and the "opkg install *.ipk".
then with the blu button you can find into the box a new section named "softcam", there you can download the original openATV oscam and you can start it by remote. Sorry for my bad english
-
try this one, if its doenst work tell me your config directory, I compile a new one for you
-
Can help me linux 32 bits?
reblin which is the dir of the config? the default one is /usr/local/etc. its right for you, I can compile it for you
-
all the best to everybody for the new year
saluti e salute