After typing the password, the nBox says 'incorrect password'. Then she says "check code decoder" and then it restarts.
So I want the nBox on the debug interface flash?
Posts by NiWark
-
-
:Push:
okay, I am now a step further. I want to nBox via the serial debug connection flashes. I am now in the service menu (dL). but I can not find a code to get into the settings. I tried that but unfortunately not work. it always get the message "incorrect password". In the manual (Polish) I found dad Password is splashing with CH.D. Is that really channeling down? or that a different meaning?
EDIT:
Because of the soldered jumper the two, I do not know where to look on the board ... -
okay, I am now a step further. I want to nBox via the serial debug connection flashes. I am now in the service menu (dL). but I can not find a code to get into the settings. I tried that but unfortunately not work. it always get the message "incorrect password". In the manual (Polish) I found dad Password is splashing with CH.D. Is that really channeling down? or that a different meaning?
EDIT:
Because of the soldered jumper the two, I do not know where to look on the board ... -
hey guys,
i am a new user from germany... my english is not so good. Sorry for that.
I have buy the polnish nBox. On the back stand "ITI-5800s" and i will flash the firmware on Nebula or OpenPLI.
I have tested both versions on this page. never work.
On my nbox ist not "BOOT" or "nBox" a first message. for me it is on display:
bb84d2a.jpgPlease help me! :sad:
