Zgemma 2s- Boots up. then it works. 2m later the pay channels don't work. Any ideas

There are 2 replies in this Thread which was already clicked 920 times. The last Post () by Neo2.

    Hey all


    I set up the Zgemma 2s box at my house last night and all was good. I brought it to my sisters, attached a new harddrive and formatted it then when I went to check the channels, the pay ones were not working. I had to bring the box back with me to figure out what the hell is going on.


    Also when you turn the power on at the back the box will boot up, THEN switch off. I switch it on and for a 1 MINUTE, it will work. Then I change to another pay channel and nothing, the box goes again but I still get free channels.


    So annoying. What did I do wrong!!


    Neo2

    • Official Post

    Okay mate you have made a few posts over the last few days with regards this box.
    My advise
    Flash it with this:
    http://linuxsat-support.com/showthread.php?t=93635
    Initialise your hard drive and reboot
    Add some picons to the hard drive
    Enable the second tuner if needed
    Edit the softcam details and enable under info panel
    do not update the image its now a few months old and there has been 100's of changes to the gui.
    Do not add anything else to the image and see if its stable.


    I still use that exact image in a bedroom with no problems.

    jenseneverest


    Dude how do I change the remote keys back to normal. How also do I change the waiting screen, the one where you have coloured bubbles? Also how do I stop automatic updates. I assume thats what you want me to do, to get no updates to any of the software???


    Tks again

Firmware, downloads and support for Zgemma Star series.

Your community resource for the Zgemma Star series satellite receiver — firmware images, channel lists, plugins and setup help.