Oscam on wetek play/pbnigma.... help!!

There are 4 replies in this Thread which was already clicked 1,465 times. The last Post () by mach1.

    Hi guys,


    ive recently installed pbnigma to my play and to an extent configured oscam but i think ive got a config issue somewhere.


    in my oscam webif i can see my nline and its showing connected but in the live log all im getting is;


    "no suitable readers available for decoding"


    and


    "rejected group no matching reader"


    do you have any ideas/advice where I might have gone wrong, im new to the whole oscam setup?

    oscam.server


    [reader]
    label = Newcamd1
    enable = 1
    protocol = newcamd
    key = 0102030405060708091011121314
    device = serverurlorip,portnumber
    user = user
    password = pass
    group = 1


    [reader]
    label = Newcamd2
    enable = 1
    protocol = newcamd
    key = 0102030405060708091011121314
    device = serverurlorip,portnumber
    user = user
    password = pass
    group = 2



    oscam.user


    [account]
    user = localuser
    user
    group = 1,2,3,4,5,6


    [account]
    user = username
    pwd = password
    group = 1,2



    oscam.conf


    [dvbapi]
    enabled = 1
    boxtype = dreambox
    user = localuser

    Vu+ Ultimo Vu+ Solo2 Vu+ Solo 4K Gigablue X1 Gigablue Quad Plus Wetekplay Wetek Core...
    4m , 2m motorized, 95 diseq usals ....

    as always many thanks to you both for replying so quickly...... just a couple of queries so im clear


    the user/pwd in oscam.user is that the user/pwd from the reader or webif or different altogether?


    and would i need to change boxtype from dreambox if my setup is wetek/pbnigma or is it irrelevant?


    - - - Updated - - -


    all working :) many thanks

    oscam.user


    [account]
    user = localuser
    user group = 1,2,3,4,5,6


    this one is for your local user u use that


    if u want to share from your receiver to other users u must open user accounts like that with username and password


    [account]
    user = username
    pwd = password
    group = 1,2


    - - - Updated - - -


    if u want to change webif username password open oscam.conf file
    [webif]
    httpport = 8888
    httpuser = admin
    httppwd = admin


    put there what port or username password u want and save it then restart oscam ..


    - - - Updated - - -


    İf u want to security u can enter only your local pc ipnumber u connect to webif then noone can connect to your oscam webif from outside u too :)
    oscam.conf file


    [webif]
    httpport = 8888
    httpuser = admin
    httppwd = admin
    httpallowed = 127.0.0.1,192.16.8.1.100 for example your pc ip is 192.168.1.100

    Vu+ Ultimo Vu+ Solo2 Vu+ Solo 4K Gigablue X1 Gigablue Quad Plus Wetekplay Wetek Core...
    4m , 2m motorized, 95 diseq usals ....

OSCam Support Forum

Configs, discussion, downloads and guides for OSCam Softcam.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login