How to force updates to your sly card

There is 1 reply in this Thread which was already clicked 2,267 times. The last Post () by master G.

  • Hi everyone found this on another Forum


    This is to force Entitlements to your sly card


    You don't have to wait for an Update you can force an Update, Place the card into the Sky Receiver and follow.


    1) Locate the button on the front of the Receiver, named "Back Up".


    2) Press and hold down the "Back Up" button...


    3) WHILE HOLDING IT DOWN, disconnect then reconnect the power to the receiver (do not release the back-up button yet).


    4) About 20 seconds after reconnecting power, all four coloured lights will illuminate on the front of the receiver.
    If the TV is switched to Sky a message will also appear on screen.. "Updating System Software".


    5) Only after the four lights illuminate and the message appears should you release the back-up button.



    6) After about 10 minutes the reciever will return to "standby" (ie. red LED only).


    7. Leave the receiver in standby for 1 minute as it carries out a self check.


    8). Switch receiver out of standby (green LED illuminates).


    9) The receiver will take a few minutes "Searching For Listings".


    This will update the firmware of the receiver and any card updates you have missed.


    Hope this helps
    Cheers

  • master G

    Added the Label Article

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!