not work mgcamd 1.38c on my vu+zero black hole 3.01. help please
not work mgcamd 1.38c on my vu+zero black hole 3.01
- tonito85
- Thread is marked as Resolved.
-
-
Use the attached version.
-
Use the attached version.
thanks master G
I installed this but still does not work
I put the line in cccamd.list -
That version does work, maybe its the c line you are using. Try with CCcam or oscam instead, then look at CCcamInfo or oscams web-interface to see if there is a problem at the server end..
-
THANKS MASTER G
I put the line in cccamd.list
not working again
where is the error that I do
attributes are all 755 -
my c-line work very well on cccam end oscam
-
C lines in mgcamd will only work if the server is using CCcam 2.1.1 and below. Do you know which version of CCcam the server uses ?
-
C lines in mgcamd will only work if the server is using CCcam 2.1.1 and below. Do you know which version of CCcam the server uses ?
CCcam-s2s| version 2.0.11 what attributes should be used to mg_cfg, cccamd.list
-
config files should be 644.
-
not work again . attributes are 644 for mg_cfg, cccamd.list .
not work for me
MGCamd Support Forum
Configs, discussion, downloads and guides for MGCamd Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!