Triax Modulator / sky & zgemma

I purchased the triax tri link modulator to setup my zgemma in a 2nd room downstairs (no problems with that part).
My issue is I can no longer watch sky in the 2nd room downstairs. It works only in the 1st room where the sky box is located.

I have set my channel to 56 on the triax box. After running automatic scan it only found 1 analogue channel at 56 (zgemma channel).
Sky use to be on channel 68 in the 2nd room but all I get now is a white snowy screen. Did I miss anything in my setup.

Just to note I also tried changing my RF sky channel on sky box from 21 through to 69 and automatic re-tuning the tv in the 2nd room but still no joy. Thanks.

This is my setup

RF1 (Out) --> free
RF2 (Out) --> the cable that use to connect to my sky RF2 (out)

RF (In) --> free
DC (In) --> wall power supply

Scart (In) --> coming from zgemma box
Scart (Out) --> going into back of tv 1

Quote from codar

Try this
Sky rf out 1 - tri link rf in
Scart from zgemma - scart (in) on trilink
Scart out on tri link - tv1
Rf 2out on tri link - sky eye (on tv2).
Ir sensor to front of both sky and zgemma receivers
Dc in - power supply
Make sure skybox frequency is different to tri link frequency and then do an analogue scan on your second tv.
Hopefully you'll pick up two channels now.

Display More

Cheers for that. I have ordered an F connector cable for what you suggested --> Sky rf out 1 - tri link rf in . Hopefully that does it for me. Thanks and will keep you posted.

Quote from ted22_8

Cheers for that. I have ordered an F connector cable for what you suggested --> Sky rf out 1 - tri link rf in . Hopefully that does it for me. Thanks and will keep you posted.

That worked a treat, up and running :hi-five: