Your advise needed .. Whats wrong wth this configuration?

There are 3 replies in this Thread which was already clicked 1,637 times. The last Post () by hislitermos.

  • Hi,


    I am running ubuntu installed 64bit pc, omnikey 3121 and 0963 card. When I run it, clients be disconnected occasionally. It stops within ten minutes then come alive again and again..


    Oscam.Log:




    Oscam.conf:


    oscam.server:



    oscam.user:
    All users are similar notation:



    Any idea why it has been happening?



    H.

  • Code
    [cccam]
    port                          = 52000
    reshare                       = 1
    version                       = 2.1.2
    keepconnected                 = 0


    above you have keepconnected to = 0
    try changing it to = 1


    also there is no need to put expiry dates in your user accounts, I think you and your peers will probably be doing other things in 10 years time beer10

    If I take a while to respond, you can see why.....


    :red:

  • Code
    [cccam]
    port                          = 52000
    reshare                       = 1
    version                       = 2.1.2
    keepconnected                 = 0


    above you have keepconnected to = 0
    try changing it to = 1


    also there is no need to put expiry dates in your user accounts, I think you and your peers will probably be doing other things in 10 years time beer10


    Thanks for your reminder but I am running the card through Nlines to CCcam so you can ommit that "CCcam" phrases. About omnikey reader driver, I am in doubt that if I did not install the correct one.
    Whats the difference between "omnikey usb driver file" and "omnikey board usb driver file" ?



    Regards
    H.

Your resource for Linux TV servers and smart card readers.

Find software downloads, drivers, and support for server setup and card-sharing configurations. Set up a Linux-based TV server. Access downloads and support for server software and USB card readers for advanced TV reception and management

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!