Hi would appreciate it if anyone can help me on oscam ecm times I only have 4 users and there ecm times are high sometimes 1000ms then 500ms ah checked with all four no sharing all 4 are on one box per house would I be able to keep them under the 100ms do I have to change any settings in config? Thanks in advance
help on how to lower ecm time (ltime) in oscam
-
- General OSCam
- leroy123
- Thread is marked as Resolved.
There are 8 replies in this Thread which was already clicked 4,812 times. The last Post () by jenseneverest.
-
-
What is your and their internet connection like ? If you have a slow connection and using a lot of bandwidth it will affect your server, the same goes for your client..
I know you are using an omnikey and the configs you use, there isn`t anything you can change on the server that will improve ecm speeds..
-
What is your and their internet connection like ? If you have a slow connection and using a lot of bandwidth it will affect your server, the same goes for your client..
I know you are using an omnikey and the configs you use, there isn`t anything you can change on the server that will improve ecm speeds..
My internet is fibre getting 68mb down and 19up
Is that ecm normal they are not freezing or any glitches just wondering what would make the ecms go so high I've not checked there broadband speed so don't no yet
-
To calculate the ecm time for a client, you add the card reader speed + ping to the client..
So for example, your servers ecm speed on 0963 card is 97 ms and the ping test to the client is 50 ms, the client should be reading your card at 147 ms.
-
To calculate the ecm time for a client, you add the card reader speed + ping to the client..
So for example, your servers ecm speed on 0963 card is 97 ms and the ping test to the client is 50 ms, the client should be reading your card at 147 ms.
My reader is showing no ecm in status it says no data ?
-
Then you need to restart oscam in putty to see if that resolves it..
-
Then you need to restart oscam in putty to see if that resolves it..
no still not there ive never seen the ms of the reader since setup?
-
Can anyone help am using am a pc for server and acs smart reader 39U I will apreciate if someone can help am getting high ecm
-
Can anyone help am using am a pc for server and acs smart reader 39U I will apreciate if someone can help am getting high ecm
you will need to post more details, the card your are using and all of the config's
OSCam Support Forum
Configs, discussion, downloads and guides for OSCam Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!