problem with smargo

There are 2 replies in this Thread which was already clicked 552 times. The last Post () by busman.

    evening all i have problem with smargo card reader , i have bt sport on omnikey port 0 works fine ,but smargo everytime i reboot pi it assigns diff device ID to ports is there way assign smargo one specific port so it stops jumping




    many thanks

    i upgraded to p3 & couldn't install raspbian-wheezy ,so if anyone
    comes same problem this is what you do load micro sd card raspbian-wheezy insert the card in your old pi & login do nothing more this four lines
    #sudo apt-get update
    #sudo apt-get update
    #sudo rpi-update
    #sudo reboot
    take card out insert in pi 3 thats it your good to go on pi3 will start with new bootloader istall your oscam then go to MASTER G post 9 in above link download 52_reader done

Your resource for Linux TV servers and smart card readers.

Find software downloads, drivers, and support for server setup and card-sharing configurations. Set up a Linux-based TV server. Access downloads and support for server software and USB card readers for advanced TV reception and management

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login