Cccam.cfg using c & n line

There are 4 replies in this Thread which was already clicked 2,395 times. The last Post () by master G.

    Hi i have two lines i want to use one is a C line other is N line
    Can i use both in cccam.cfg? I can't change lines as they won't work
    I.e converting c line into n line or vice versa

    Quote

    Can i use both in cccam.cfg?


    Yes, both should work together on the same receiver (version 2.3.0 is needed for dual tuner receivers to decrypt two channels together, watching and recording etc.)

    Would i be right in saying, that the c-line would run a sat tuner, and a n-line would run a cable tuner, on a dual tuner box with both sat and cable tuners installed in the box.... is this correct ??

    • Official Post
    Quote from wullboy

    Would i be right in saying, that the c-line would run a sat tuner, and a n-line would run a cable tuner, on a dual tuner box with both sat and cable tuners installed in the box.... is this correct ??


    Not necessarily, both cards could be shared via C line or N line, just depends on how the server has configured the cards within OSCam..

Your resource for CCcam softcam

Find downloads, configuration files, setup tutorials, and community support for card sharing and server management. Master CCcam configuration and card sharing. Access dedicated support, step-by-step tutorials, config files, and downloads for your Enigma2 setup.