Hi,
Aim: I would like to run my pcsc (omnikey) readers with usb powered hub.
System Configuration:
Ubuntu 11.04 PC
2 pcs NDS cards
2 pcs Omnikey3021 reader
1stcard is in usb hub, device 0
2nd card is in usb hub, device 1
Case 1:
Both cards working normally.
Omnikey readers are inserted into usb ports.
There is no question.
Here is my oscam conf:
[reader]
label = s*y**
protocol = pcsc
device = 0
caid = 0963
boxid = ********
detect = cd
ident = 0963:000000
group = 1
blockemm-unknown = 1
blockemm-u = 1
blockemm-s = 1
blockemm-g = 1
audisabled = 1
[reader]
label = s*y**
protocol = pcsc
device = 1
caid = 09cd
boxid = ********
detect = cd
ident = 09cd:000000
group = 2
blockemm-unknown = 1
blockemm-u = 1
blockemm-s = 1
blockemm-g = 1
audisabled = 1
Case2:
At this step, I will try to run powered usb hub.
When I intend to run a powered usb hub which has eight slots:
I remove both omnikey readers from usb port, then insert both them into powered usb hub.
Then I type "lsusb" on ssh panel.
Here is the result:
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 006: ID 076b:3021 OmniKey AG CardMan 3121
Bus 001 Device 005: ID 05e3:0608 Genesys Logic, Inc. USB-2.0 4-Port HUB
Bus 001 Device 004: ID 076b:3021 OmniKey AG CardMan 3121
Bus 001 Device 003: ID 05e3:0608 Genesys Logic, Inc. USB-2.0 4-Port HUB
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
This is my oscam conf file:
[reader]
label = s*y**
protocol = pcsc
device = xxx
caid = 0963
boxid = ********
detect = cd
ident = 0963:000000
group = 1
blockemm-unknown = 1
blockemm-u = 1
blockemm-s = 1
blockemm-g = 1
audisabled = 1
[reader]
label = s*y**
protocol = pcsc
device = yyy
caid = 09cd
boxid = ********
detect = cd
ident = 09cd:000000
group = 2
blockemm-unknown = 1
blockemm-u = 1
blockemm-s = 1
blockemm-g = 1
audisabled = 1
My question is that what should be xxx and yyy parameters for this system?
-Should I run two different powered usb hub for two omnikey readers or may I use the same usb hub for both nds cards?
-As I am gonna run two cards, should I reduce usb port reading speed from 480Mhz to 12Mhz?
Thanks in advance
Hislitermos