Ariva 150 Eprom Upgrade problem

There are 3 replies in this Thread which was already clicked 1,276 times. The last Post () by _Gigino_.

    HI Guys
    I try install new patch but, something goes wrong.
    I have a 150 Ariva and downloaded the latest firmware from the Ferguson website V1.27B9 and the EROM UPGRADE TOOL 2.0.0c


    I also got a Null Modem Cable RS232. Went through the procedure as explained here in another post http://linuxsat-support.com/at…mentid=21992&d=1392222869
    I set my port : to COM 1 , BIT RATE : 115200 , PARITY : EVEN , OPERATE MODE : UPGRADE and i checked INCLUDE BOOTLOADER.
    Next I power on my Ariva. ANd there is problem.


    On STB EROM upgrade tool still display
    Synchronizing STBs
    Please reset target.


    I wait few minutes, nothing happends.


    I checked COM port (loopback test look's good), I check cable, (connections are ok, identical like ariva cable).
    I think bootloader is ok. when i connect Ariva to TV there I can see some screen with splashscreen, next on 1 sec settings and screen goes black.

    Quote from velkhor

    On STB EROM upgrade tool still display
    Synchronizing STBs
    Please reset target.


    At this point, reboot your decoder from the rear button and follow the instructions on the screen ;)

    Vu⁺ Solo² (OBH 5.3.xxx) & Vu⁺ Zero (OBH 5.3.xxx in fallback) - Vu⁺ USB Tuner DTT T2/C Turbo - Amiko Viper 4K v40 (OBH 5.3.xxx)

    - Dish Fracarro R0100APX5G - Inverto Black Ultra Single 0,2 - Rotor PowerTech DG380 (39.0° E ÷ 30.0° W)

    Colui che chiede è stupido un minuto, colui che non chiede è stupido tutta la vita.

    Those who ask are stupid for a minute, those who don't ask are stupid for life.

    Yes. I know that. I reboot many times.
    I reset using rear switch.
    I power off rear switch, disconnect plug from AC, connect AC power ON switch.
    It's doesn't help.

    Quote from velkhor

    Yes. I know that. I reboot many times.
    I reset using rear switch.
    I power off rear switch, disconnect plug from AC, connect AC power ON switch.
    It's doesn't help.



    you just have off / on switch. you do not disconnect the AC cord

    Vu⁺ Solo² (OBH 5.3.xxx) & Vu⁺ Zero (OBH 5.3.xxx in fallback) - Vu⁺ USB Tuner DTT T2/C Turbo - Amiko Viper 4K v40 (OBH 5.3.xxx)

    - Dish Fracarro R0100APX5G - Inverto Black Ultra Single 0,2 - Rotor PowerTech DG380 (39.0° E ÷ 30.0° W)

    Colui che chiede è stupido un minuto, colui che non chiede è stupido tutta la vita.

    Those who ask are stupid for a minute, those who don't ask are stupid for life.

Participate now!

Don’t have an account yet? Register yourself now and be a part of our community!

Register Yourself Login