right got me uno today done initial setup wot to do next have followed the dummies tut but not shore about cccam dont think its installed
scouse
p.s using latest bh image
right got me uno today done initial setup wot to do next have followed the dummies tut but not shore about cccam dont think its installed
scouse
p.s using latest bh image
Start with your image you want to use and then use the right cccam for your image m8 ?
Adding TS panel would be a good thing to do now,makes it easy to install add-ons.
In there under Linuxsat support menu you will find cams etc and also ready made configs for most cards,you can also download them from here in the forum.
Are you planning to use ccam alone or oscam+ccam?
Install TSPanel for all the cams & addons you need.
New-TSpanel enigma2 plugin,everything you need for your image
do i install this by usb ten
hi chaps got box set up now but cant seem to scan any sats only sly sat,everything with dish was ok when using me db 500 any ideas
scouse
What channel list are you using bud? (catseye,sgt flip flop etc)
are you using usals to move the dish??
catseye m8 and yes usals
Goto your main menu,select setup
select setup
select service searching
select tuner configuration
check that your configuration mode is set to "advanced" then go through the settings in there
Then goto manual scan
in that menu change "satellite" to the one you want to scan "19.2e/23.5e etc"
then change "network scan" to "yes"
then change "clear before scan" to "yes"
Press ok to start scan
Then goto manual scan
in that menu change "satellite" to the one you want to scan "19.2e/23.5e etc"
then change "network scan" to "yes"
then change "clear before scan" to "yes"
Press ok to start scan
were u put change satellite its ony giving me 2 sat options 19.2 and 28.2
you need to load a new satellites.xml file then. or a decent bluquet pack.
Don’t have an account yet? Register yourself now and be a part of our community!