how to install image OPEN AAF , in GIGABLUE 800 HD SOLO ?

There is 1 reply in this Thread which was already clicked 2,669 times. The last Post () by musogeek.

    It is very simple - just download the image, unpack, and there are three files- vmlinux.gz, burn.bat, and rootfs.img. just put these straight on the root of a formatted USB flash drive. Place the USB flash drive in the USB port at the back, switch the GigaBlue off and on, and wait about half an hour. The front LED will tell you that it is loading and will count up to 100 a couple of times, and just make sure when it has been installed you remove the flash drive before doing any full restart.

    If I take a while to respond, you can see why.....


    :red:

Your support hub for the GiGaBlue receiver.

Help, firmware and downloads for the GiGaBlue Enigma2 satellite receiver. Ask about setup, channel lists, plugins and troubleshooting.