Hi All.
I have done a fresh install of a debian distro and used the tutorial for oscam + single cccam server
http://linuxsat-support.com/sh…d-3-running-CCcam-servers
I was following this tutorial http://linuxsat-support.com/showthread.php?t=1712
to install my Omnikey 3121 and the lines below are not in opensc.conf
----------------------------------------------------------
#reader_drivers = pcsc, ctapi;
#try_emulation_first = yes;
#lock_login = false;
Remove this line; (why remove it's already #)
#provider_library = /lib/libpcsclite.so.1
------------------------------------------------------------
# The following section shows definitions for PC/SC readers.
reader_driver pcsc {
# Limit command and response sizes.
# Default: max_send_size = 255, max_recv_size = 256;
# max_send_size = 0;
# max_recv_size = 0;
#
# Connect to reader in exclusive mode?
# Default: false
# connect_exclusive = true;
#
# What to do when disconnecting from a card (SCardDisconnect)
# Valid values: leave, reset, unpower.
# Default: reset
# disconnect_action = unpower;
#
# What to do at the end of a transaction (SCardEndTransaction)
# Valid values: leave, reset, unpower.
# Default: leave
# transaction_end_action = reset;
#
# What to do when reconnection to a card (SCardReconnect)
# Valid values: leave, reset, unpower.
# Note that this affects only the internal reconnect (after a SCARD_W_RESET_CARD).
# A forced reset via sc_reset() always does a full powerup.
# Default: leave
# reconnect_action = reset;
#
# Enable pinpad if detected (PC/SC v2.0.2 Part 10)
# Default: true
# enable_pinpad = false;
#
# Use specific pcsc provider.
# Default: libpcsclite.so.1
# provider_library = libpcsclite.so.1
}
The pcscd file is editable as to the tutorial DAEMON_ARGS="-e"
So if I'm missing something, probably am, a little help please.
