sorry if I write here there CCcam for all E2 boxes with ARM for
vu + solo 4k
thank you
CCcam for all E2 boxes with ARM
-
- Various Support
- megan
- Thread is marked as Resolved.
-
-
Hi only oscam but is easy to put c line see my replay on vti vu uno 4k
-
excuse better explained as putting c line because I'm not so expert
thank you -
IN OSCAN PUT HOST,PORT USER AND PASSWD
[reader]
label = line_cccam
enable = 1
protocol = cccam
device = HOST,PORT
user = USER
password = PASSWD
inactivitytimeout = 30
fallback = 1
group = 3
cccversion = 2.3.0
ccckeepalive = 1- - - Updated - - -
IF YOU HAVE PROB I CAN HELP YOU VIA TEAM VIEUWER IF YOU ACCEPT ?
-
because when I buy the decoder you show me how to put it to work
in ccam -
Which image are you using megan ?
-
Not on vu solo 4k if was ccam was another box budy
-
I repeat as I can tell when I buy the decoder
I imagine that I put so we can figure out how to make it work in cccam
thanks again -
every thing at the right time!
1. buy the decoder
2. flash box
3. configure oscam ... -
As already stated, CCcam doesn`t work on any ARM based receiver.. The softcam of choice is OSCam..
When you receive the solo4k, get back to us and tell us which image you are using, then we can direct you to whats needed..
-
-
Witch box you have please
-
Hello
I converted the oscam with cccam cccam converter okay
as I said just vu + 4k can work this way
thanks again -
yes with not prob
-
Hello
I converted to oscam with cccam cccam converter okay
as I said just vu + 4k can work this way
thanks again- - - Updated - - -
sorry for the same answer again thanks
-
Ok easy if you have c line you can convert to oscam or follow my answer post above
- - - Updated - - -
IN OSCAN PUT HOST,PORT USER AND PASSWD
[reader]
label = line_cccam
enable = 1
protocol = cccam
device = HOST,PORT
user = USER
password = PASSWD
inactivitytimeout = 30
fallback = 1
group = 3
cccversion = 2.3.0
ccckeepalive = 1
Your resource for CCcam softcam
