Hi experts.. pls help
i have vu+ SOLO SE and i have tried mgcamd with cccam.list.. why it is not working only newcamd.list is working....
Vu+ SOLO SE Mgcamd cccam.list is not workin
- anilw
- Thread is marked as Resolved.
-
-
The server must be using CCcam 2.0.11 to get a c line working in mgcamd / cccamd.list
Maybe the mg_cfg isn`t configured for both newcamd & cccamd protocols.
Make sure you have this in mg_cfg (01+32=33):
Code# network mode, use summ for several clients # 00 no network (default) # [COLOR='#FF0000']01[/COLOR] newcamd netclient # 02 radegast netclient # 04 camd3 netclient # 08 gbox netclient # [COLOR='#FF0000']32[/COLOR] cccamd netclient, card list saved as /tmp/cccamd.info # (ECM only, supported server version up to 2.1.1, later not work) [COLOR='#FF0000']G: { 33 }[/COLOR]
-
Hi MasterG;
Tks for the reply, yes my C line is 2.0.11 only and i have confgured G= { 33 } but still it snot working...any idea...
-
cccamd.list or cccam.list? must use file with name cccamd.list
-
ya yah its only cccamd.list
but still not working.. pls help
-
mg_cfg
# network mode, use summ for several clients
# 00 no network (default)
# 01 newcamd netclient
# 02 radegast netclient
# 04 camd3 netclient
# 08 gbox netclient
# 32 cccamd netclient, card list saved as /tmp/cccamd.info
# (ECM only, supported server version up to 2.1.1, later not work)
G: { 33 }**************************************************
# box type
# 00 autodetect, change only if you think wrong type detected.
# 01 dbox2
# 02 dreambox
# 03 triple-dragon
# 04 relook
# 05 openbox
# 06 dreambox/mips
# 08 stapi/kathrein
# 09 stapi/ipbox
# 11 stapi/openbox
B: { 06 }Try B: {00} or type of your box
-
Hi tks for the reply, i have tried the way you have explained (i.e B= { 00 }
but still chs are blank
http://joxi.net/Drloa8Zcvx3QVA.png
http://joxi.net/xAeDGnQup5leY2.pngbox send the request for ecm.. pls see the following as well
http://joxi.net/Y2LYj3PI9qdGeA.png
Pls help..
(NOTE: I could not upload photo.. that is why i have pasted the link)
MGCamd Support Forum
Configs, discussion, downloads and guides for MGCamd Softcam.
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!