help needed
how to install new image to DM7080 HD
How to install image i DM7080
- benssv1
- Thread is marked as Resolved.
-
-
If the dreambox is in standby mode, the Rescue Loader can be activated by continuously pushing the power button on the front panel of the dreambox.
If the dreambox has been switched off with the power switch at the back, the Rescue Loader can also be activated. Keep the power button pushed at the front panel and switch the power button to ON.
The display will show Enter setup? and 3 seconds later the box will stop in the Rescue Loader mode. Now the display will show the IP address which can be used to access the Rescue Loader. Enter the address in your web browser (e.g. Firefox), e.g: http://192.168.1.1
Choose Firmware upload.
Use browse... to select the image.
Start the upload with Go!.
After the successful installation, click Click here to reboot to reboot the dreambox.
Have fun with the configuration of the new image.
-
shall i use this kind of image to upload
Merlin-4_OE-2.5-dm7080-experimental-20170107.tar -
Yes, that will work on your receiver..
Participate now!
Don’t have an account yet? Register yourself now and be a part of our community!