Need help with Unicable II installation with 2 satellites dishes

Hi

I need some help, her is my situation:

I have 2 Motorized (STAB HH120) satellites dishes

Each dish has a Inverto IDLU-32UL40-UNBOO-OPP Unicable II LNB

These 2 LNB are connected to Unicable II 2-way Combiner IDLU-UCM1O1-OOO2O-OPP

From there a single cable goes to 2 receivers (Octagon SF4008 and VU+ SoloSE2) using OpenATV 6.0 image

I have also added a Unicable II Power Inserter, IDLU-PINS02-OOOOO-OPP between combiner and receivers

I have tested one dish alone, everything work fine without the 2-way Combiner IDLU-UCM1O1-OOO2O-OPP .

I tried different combinations without any result no signal at all

The question is how do I configure the tuner each receiver control their own satellite dish.

Here is what I can change :

Tuner A

Configuration Mode: Advanced

Satelitte : All Satelites

LNB: LNB 1

Priority : AUTO

LOF: UNICABLE/JESS

Unicable Configuration mode: Unicable LNB

Manufacture: Invereto

Type: IDLU-32UL40-UNBOO-OPP

Channel - SCR1
Frequency – 1210

Tuning algorithm: reliable

Fast DiSEqC: None

Toneburst : None

DiSEqC 1.0 Command: None

DiSEqC 1.1 Command: None

Sequence repeat: No

Longitude xxx.yyy East/West

Latitude xxx.yyy North/South

Kind regards

Iradj

Hi

will my installation; 2 receivers control their own motorized satellite dish with single cable ever work?

Is there any hardware or software that will help?

Any suggestions that I should try?

Regards

Iradj